How To Get Air Bubbles Out Of Screen Protector (2023)

Table of Contents

How To Get Air Bubbles Out Of Screen Protector

If you have air bubbles along the edge of your screen protector, you should try to remove the air bubbles. You should lift the side of the screen protector with a thin piece of plastic by keeping your fingers and natural oils away. Then, shift the screen protector to the same position.

Flatten your screen protector down to the edges of the phone using a credit card, forcing air bubbles to go away. You can either use an applicator tool, which is usually included in the box with most screen protectors, or you can use the edge of your credit card, pushing air bubbles all the way down the edge of your phone. If bubbles do occur while installing, try using a plastic non-oily tab, such as a credit card, to push each bubble toward the edge of your screen and away from your screen protector.

Some screen protectors actually include little plastic pieces that will help you scrape the bubbles off securely, but if you do not have something handy, the edges of a credit card should do.

These bubbles might have appeared due to dust particles trapped underneath your screen protector, and you can remove them using simple accessories like a credit card or a squeegee. There are typically several bubbles caused by airborne dust particles, regardless of how carefully you are working. If you are dealing with dust particles or imperfections on the screen itself, you cannot expect those bubbles to disappear by themselves.

If the faux air bubbles do not disappear in 24 hours, it is possible that dust particles are still present on the phone screen underneath your screen protector.

The final reasons why air bubbles can form are a poor setup, dust, or oily fingerprints on the screen. Dust on the screen itself is another common reason why air bubbles can form after the protector is installed.

If you have not cleaned your screens surface well, there may be small dust particles left behind which can cause bubbles to form when the protector is installed. Now, you will want to clean your screen completely using a soft, lint-free cloth to get rid of any dust or oily fingerprints.

Thoroughly clean the iPhones surface prior to applying screen cleaner to the screen in an area that is free from dust (do not apply to your phone outside). If you must begin again, you can remove the screen from the iPhone, wash it in soapy water, and then thoroughly dry it.

After using a clean, lint-free cleaning cloth, use the dry part of the cleaning cloth, or new one, and clean the screen on the device completely. To get rid of any dust or lint, wet the corners of your microfiber cleaning cloth (if you do not have one for screens, try using rubbing alcohol) and run it over your devices screen. You can also lightly dampen the corner of a cloth with rubbing alcohol and wipe it over the devices screen to remove any remaining debris.

Use a minimum amount of oil to moisten your cotton pad, since too much oil may make the phone harder to clean. If you find bubbles along the edges of the screen, lightly grease the tip of a cotton swab with cooking oil and run the swab over the edges where the bubbles are.

If the bubbles seem not to be going away from the edges of your protector, you have a choice to remove it using a bit of oil. If air bubbles are not going away after applying the oil, gently raise the edges of your screen protector using a fingernail or a razor blade so that oil gets inside. When air bubbles get close to the screen edge, lift up gently on the sides of your screen protector to let air out.

Push outwards from the center of the screen toward each edge to compress any trapped air. Starting at the center of the screen, push out the air toward the edges.

From the center, exert even pressure, pushing down across your devices screen outwards to the edges in all directions. Apply light pressure and push your plastic tab outwards from the center of your screen toward the edge. Make sure you do not press the credit card against the iPhone too hard, because it can cause damage to your devices screen.

Gently slip the credit card under the raised corners, then run it around the sides of your iPhone slowly. That is right — take a drivers license, credit card, or debit card, and push air bubbles toward the edges of your screen using the edges of your drivers license.

For removal, you will need a scotch tape piece and a plastic card (like your credit card) which you will use to dabs the device screen with, helping remove dust and debris which may have been missed prior to the first time you used it. If you are experiencing lingering dust on the screen, tempered glass, you will probably want to use a piece of scotch tape.

You bought your tempered glass to protect your devices screen, but those bubbles may disrupt your touchscreens sensitivity. If bubbles are all over the phone screen, you can remove tempered glass safely with a razor blade.

If one bubble becomes stuck close to an edge and cannot be removed, gently pull up on the nearest corner of your screen protector using a small, thin plastic scrap. If you push on the middle back side of an OtterBox Defender case, the bubbles return, but the corners are lifted up, and the bubbles are removed by snapping them back on.

Press firmly – but not too hard – and slide the bubble up the edges of the Protector, lifting up a little bit to allow the air to escape. Then, lay it over the top of the screen and see how well it bonds with your devices surface. Just do not touch the bottom of the screen protector, so that the glue will stick to the phone screen anyway.

Sometimes the pressure of dropping the iPhone on your screen will make the protector move around and form air bubbles all of a sudden. After washing and drying your hands thoroughly, you may also want to try using your fingers to gently press bubbles away. It might take a fair amount of swipes on the screen to completely get rid of air bubbles, but you may want to use some of that low-temperature blow drying to aid in the process.

Will air bubbles go away on a screen protector?

Small moisture bubbles are frequent and disappear by themselves. Try leaving the pen head-sized and smaller bubbles alone; they will go away AS LONG AS IT’S A MOISTURE BUBBLE. This will prevent people from ripping off screen covers and attempting to reapply their bent-out and fingerprinted soft screen protectors.

How long does it take for air bubbles to get out of the screen protector?

Air bubbles can sometimes be eliminated with patience; all you need to do is wait 24 to 48 hours, and the bubbles may go on their own. There’s a strong possibility you have an air bubble removal tool in the wallet if time doesn’t work.

Why does Apple not sell screen protectors?

Apple is removing protection goods off its stores, but has not yet stated why. One common theory is that Apple wants to promote the impression that the screens on its products are durable enough to not require protection, despite the fact that everyone who has fallen an iPhone knows this is not the case.

Related posts:

  1. Black Iphone Wallpapers
  2. Lyrics To Apple Bottoms Jeans
  3. Is 256Gb Enough For Macbook Air
  4. Macbook Cycle Count
  5. Macbook Pro Water Resistant
Top Articles
Latest Posts
Article information

Author: Van Hayes

Last Updated: 12/01/2022

Views: 6422

Rating: 4.6 / 5 (66 voted)

Reviews: 89% of readers found this page helpful

Author information

Name: Van Hayes

Birthday: 1994-06-07

Address: 2004 Kling Rapid, New Destiny, MT 64658-2367

Phone: +512425013758

Job: National Farming Director

Hobby: Reading, Polo, Genealogy, amateur radio, Scouting, Stand-up comedy, Cryptography

Introduction: My name is Van Hayes, I am a thankful, friendly, smiling, calm, powerful, fine, enthusiastic person who loves writing and wants to share my knowledge and understanding with you.